Good afternoon. Help to solve problems with the Bally Wulff Megastar II.
Error codes 61F, 41F, EEF.
Bally Wulff Megastar II problem
-
mikesat -
24. Juni 2015 um 19:56 -
Erledigt
-
-
Hi,
i hope i can help you...

Error Code: 61F = left engine asynchronously. Please clean the photoelectric / light barrier.
Error Code: 41F = is an error message for a bill acceptor. Do you have a bill acceptor in the machine ? Then please remove the cable from the bill acceptor. Normally you not need the bill acceptor. He only works with German mark bank notes. Then the error E41 will be gone.
Error Code EE F: There are two possible causes. First cause ist the easiest; Slot machine to often turn on and off. Second cause; the battery on the controller board is empty. Please change the battery.
Possibly, after clearing the photoelectric error, the Slot machine works without error.
-
Thank You. May be you have service manual for this slot machine?
-
I have a servive manual. This is not for this slot machine "Mega II" but the error codes are the same.
-
Thank you very much. May be you have electrical circuits? I have from Lord of teil but It does not quite fit.
-
Here is the manual for "Rex" from Bally. The electrical circuits are the same.
-
Hello again. Tank for electrical circuits.
I cleaned the photoelectric. I pulled the wire for a bill acceptor.
Change the battery.
But there was an error 61F.
When the wheels are trying to turn, but does not spin, and an error 61F. What else can I try to do?
Thanks in advance. -
-
Hello,
first please disconnect the bill acceptor. In the video i can hear how the bill acceptor starts. Then normaly the error "C(G) Err" before E61 is gone.
Then please check again the photoelectric / light barrier in the left engine. The error E61 says "engine asynchronous"
See the picture that we have no misunderstanding for the left engine...

-
I think maybe some problems with the power supply? I changed the wires between the left, center and right engines, but the error code is not changed, also 61F error code

You are not alerted that the lights does not shine brightly and engine will not start?Thanks in advance.
-
When the error is not changed when you change the wires between the engines then you have unfortunately a another problem.
I mean, there may be a problem with the controller board. But since I can not help you because I'm no electrician, sorry.
We have an electrician User here but he is in holyday now. Perhaps he can help you when it is back.
Have an nice weekend
Micha -
Thanks, I'll wait.
Jetzt mitmachen!
Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!